Mini Caddyshack Costume

I'm standing inside the costume and it rolls around on wheels. Most of the materials are laying around peoples garages or can be found at local hardware store like Lowes. There really isn't a right or wrong way to make this costume just use your imagination and build it how you want. I used the plywood for the deck and attached that to a wooden frame on wheels. I used a jigsaw to cut my plywood and to cut all the holes in the plywood. I then covered the plywood with indoor outdoor carpet. I built a small windmill out of scrap wood and then places a small motor on top that ran off a 12 volt battery. The windmill would turn and I had to putt through it to make the shot. The gopher would dance at the push of a button that was located near me. I used old an old down spout pipe to create a ball return after I made a putt. Hope you like it!

Materials Used
1. 1 4x8 sheet of 1/2inch plywood
2. 7 8ft long 2x4 economy studs
3. 4 caster wheels
4. Downspout drain pipe or something similar to make the ball return
5. Various scrap pieces of foam to create the bank
6. A small motor that runs on 12 volt battery to run the windmill
7. Reostat to slow down the motor speed
8. Milk jug for the ball bucket
9. Indoor outdoor carpet
10. Dancing gopher
11. Screws, glue, staples
12. Accrylic Paint for the signs
13. Various plywood pieces to build windmill and signs
14. Construction adhesive
15. Staples, Screws, Nails
16. Wire, wiring adapters etc
17. 12 volt battery